Fenix LD22 XP-G2(R5) LED 300 Lumens Tactical Flashlight

Specifications:

Name: Fenix LD22 XP-G2(R5) LED 300 Lumens Tactical Flashlight

Categories: Tac lights

Brand: Fenix Flashlight

Features:

1. Using XP-G2 R5 LED, the service life can reach 50,000 hours

2. Powered by two AA (Ni-MH/Alkaline) batteries

3. 155 mm (length) x 21.5 mm (diameter) 6.1 inches x 0.8 inches)

4. 72 grams (2.5 ounces), not including batteries

5. Tactical tail switch, instantaneous opening function

6. Stainless steel switch for output selection in outdoor mode

7. Dual operation mode and outdoor mode are factory default settings

8. Intelligent memory circuit (in outdoor mode), automatically enter the brightness level used last time when power on

9. Digitally regulated output maintains constant brightness

10. Reverse polarity protection to prevent improper battery installation

11. Made of durable aerospace-grade aluminum Premium type III hard anodized anti-wear surface

12. Tempered ultra-white glass lens with anti-reflective coating

Mode Switching:

When the light is on, press and hold on the side switch for 3 seconds till the LED flashes twice at Low output, and then to cycle through Tactical Mode → Outdoor Mode.

Outdoor Mode:

1. ON/OFF:

Slightly tap the tail switch to turn on the light temporarily, release it the light will go out. Fully press on the tail switch to turn on the light constantly, press once again to turn it off.

2. Output Selection:

With the light on, single-click the side switch to cycle through Low→Mid→High→Turbo.

Notice: Under this mode, the flashlight memorizes the last used brightness level. The next time you turn it on, it will recall that previously brightness level, but it will not remember the Strobe/SOS.

Strobe and SOS:

With the light on, long press the side switch for 0.5 second to enter Strobe mode. Under Strobe mode, click the side switch to circle through Strobe→SOS. Long press the side switch again to turn back to general mode.

Tactical Mode:

1. ON/OFF:

Fully press on the tail switch to turn on the light constantly, press once again to turn it off.

2. Output Selection:

Slightly tap the tail switch to turn the light on temporarily, release it the light will go out, tap the tail switch again in 1 second, the light will cycle through Turbo → Strobe → Mid.

Continue to fully press on the tail switch after selecting the needed output mode, the light will last on present output mode.

Notice: 

1. Under this mode, Turbo mode is defaulted when the light turned on.

2. Under this mode, the side switch only works on Mode Switching.

Warning:

The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the light directly into anyone’s eyes.

Package Included:

1 x Holster

1 x lanyard

1 x spare O-rings

1 x two AA Alkaline batteries